Category Calculations (Calculation)

These are Designing-related properties and vary depending on the type of device and type of network being calculated:

• Hydr. Start Plan - Results of hydraulic calculations at the start of the plan, i.e., dimensioning
  • Linear Devices
  • Point Devices
• Hydr. Final Plan - Results of hydraulic calculations at the end of the plan, i.e. at the check
  • Linear Devices
  • Point Devices
• Rule Result - Results of rule calculations
  Shows the results of evaluating the rules, if applied to the device, or geometry errors
• SWMM - when the network to which the device belongs is drainage or sewer and this is enabled to calculate in SWMM
• EPANET - when the network the device belongs to is a Pressure Network

On the Properties Tab, three buttons will appear when a pipe is selected:

• pipe properties (section, style, identification, etc)
• Hydraulic section properties in design
• Hydraulic section properties on verification