Rules
Rules are limits that pipe or structure must satisfy.
In the previous C3DRENESG, the verification of these elements
should be done in exclusivelly in Toolspace.
Now C3DRENESG, implements a
own set of rules separate from those that come with Civil 3D.
These new Rules are implemented as extended data.
To edit, you must use the command 
CEDITRULES.
If you've used the previous version (version C3DRENESG4 C3DRENESG2 or 2736 or
above), use the command 
UPDATERULES, so that the rules are converted to this new version.
First, open your parts list (command EDITNETWORKpartslist)
it, click the tab Pipes and click on it 's column "Rules":
Note: that you can set the same rule for all pipe partsize.
To do this click the "floppy" in the Rules column.
If you prefer to define a set of Rules for each partsize, click Rules in the column corresponding to each line partsize.
The screen that opens will show:
Note: that the rules defined in this screen, NOT BE USED FOR C3DRENESG
WORKSHEET
.
Only the names of the rules will be COPIED and used by the rules of C3DRENESG, which should be edited with the command
CEDITRULES.
The rules are defined for:
These new rules NEED be
defined Civil 3D, but the spreadsheet does not know the boundaries to be
checked during the calculation.
Structures