Transverse Excavation Sections

Each transverse excavation section has the following properties:

• Location
  • Distance (Distance, Double) - distance from device start
  • X (X, Double) - X ordinate of the stake on the device axis
  • Y (Y, Double) - Y ordinate of the stake on the device axis
  • Angle (Angle, Double) - angle of the tangent to the axis at the section station
  • Bottom Elevation (BottomElevation, Double) - dimension at the bottom of the ditch
  • Surface Elevation (SurfElevation, Double) - dimension on the excavation surface
  • Depth (ExcavationDepth, Double) - Depth of the trench (ExcavationDepth = SurfElevation - BottomElevation)
• Right Side
  • Ditch Right Offset (RightTopOffset, Double) - offset distance from the axis to the right side
  • Right Ditch Elevation (RightTopElevation, Double) - offset elevation on the right side
• Left Side
  • Ditch Left Offset (LeftTopOffset,Double) - offset distance from the centerline to the left side
  • Left Ditch Elevation (LeftTopElevation, Double) - offset elevation on the left side
• Shoring
  • Shoring (ShoringHeight, Double) - value of the height of shoring on the stake
• Sections
  • Displace Ditch (DisplaceDitch, Double) - Displaces the axis of the ditch relative to the axis of the device
  • Trench Height (TrenchHeight, Double) - height between insertion point and top of cradle, used to calculate total trench height ditch in each picket
  • Trench Width (TrenchWidth, Double) - total width of the excavation trench, measured perpendicular to the axis
  • External width (OutWidth, Double) - external width of the cross-section
  • OutHeight (Double) - altura externa de la sección transversal
  • Outer Area (OutArea, Double) - External area of ??the cross section of the device for calculating the excavation
  Note: If the device modeler implements the variable trench extra flow, these values ??may vary from section to section
• Areas
  • Manual excavation (EMan, DOuble) - manual excavation area
    Corresponds to the cradle, or regularization of the bottom of the trench
    
  • Mechanical Excavation (EMec, Double) - mechanical excavation area
    Corresponds to the excavated area to the bottom of the device, not counting the cradle
  • Full Refill (Rtotal, Double) - total refill area
    
  • Mechanical refill (RMec, Double) - mechanical refill area
    Corresponds to the refill area above the device
  • Out Area (OutArea, Double) - Out area of device section
  • Manual refill (RMan, Double) - manual refill area
    Corresponds to the refill area at the external height of the device
    
• Calculations
  • Excavation Errors (ExcavationError, Enum) - Errors that occurred during the excavation calculation
  • Rule Results (RulesResult, ListExpressionResult) - Results of rule calculations

These values ??are visible on the Excavation tab