Solids Builder - Subtract

Subtract - Subtracts the selected solids from a solid:

This activity is used to compose a complex solid, for example, to draw a manhole mouth and open the holes in the wall Where: the pipes connect:

The Subtract activity has the following properties:

• Identification
  • Name - extrude name
    The activity name must follow the naming rules
  • Visible Object - indicates whether or not the point should be drawn in the preview
    
    
  • Source Solid - name of solid of origin, from which the selected solids in the list will be subtracted
  • Solids to Subtract - indicates the list of solids to be subtracted from the source solid. At least one solid must be selected

The Subtract activity requires an editor of the list of solids. This editor is the same as the Polyline activity.

They are as follows:

• Move to Start - move selected items to the beginning of the list
• Up - move up selected items in a position
• Down - down selected items in a position
• bottom - move selected items to the bottom of the list
• add - add the selected items in the left list (points available) to the right list (points used)
• Remove - removes selected items from the list on the right (points used)
• Select all - select all items
• Invert Selection - invert selection from list
• Apply - apply the list selection to the activity.
  In order to be drawn with the chosen items, you must click this button

If the text is too big/small, or the sphere representing the point is too big or small, use the buttons ( A, a, , ) at the top of the screen to change the preview