Solids Builder - Intersect

Intersect - Creates a solid by intersecting solids selected in the source solid:

This activity is used to compose a complex solid, for example, to draw a manhole mouth and open the holes in the wall where the pipes connect:

The Intersect activity has the following properties:

• Identification
  • Name - extrude name
    The activity name must follow the naming rules
  • Visible Object - indicates whether or not the point should be drawn in the preview
  • Source Solid - name of the source solid, from which the selected solids in the list will be subtracted
  • Solids to Intercept - indicates the list of solids to be intercepted in the source solid. At least one solid must be selected

A atividade Subtrair requer um editor da lista de sólidos. Este editor é o mesmo da atividade Polilinha:

The Intersect activity requires an editor of the list of solids. This editor is the same as the Polyline activity.

They are as follows:

• Move to Start - move selected items to the beginning of the list
• Up - move up selected items in a position
• Down - down selected items in a position
• bottom - move selected items to the bottom of the list
• add - add the selected items in the left list (points available) to the right list (points used)
• Remove - removes selected items from the list on the right (points used)
• Select all - select all items
• Invert Selection - invert selection from list
• Apply - apply the list selection to the activity.
  In order to be drawn with the chosen items, you must click this button

If the text is too big/small, or the sphere representing the point is too big or small, use the buttons ( A, a, , ) at the top of the screen to change the preview