Solids Builder - Transition

Transition - creates a solid by transitioning two flat figures ( circleor polyline):

This activity is used in manholes, Where: there is a transition cone between the body that is normally rectangular and the chimney, which is circular:

The Transition activity has the following properties:

• Identification
  • Name - extrude name
    The name of the transition must follow the naming rules
  • Start Figure - name of the initial section, it must be a flat figure ( circleor polyline)
  • End Figure - name of the final section, it must be a flat figure ( circleor polyline)
  • Visible Object - indicates whether or not the point should be drawn in the preview
    
    

If the text is too big/small, or the sphere representing the point is too big or small, use the buttons ( A, a, , ) at the top of the screen to change the preview