Operation

1. You must have a project in Civil 3D, which contains alignments that represent gutters.
2. You should read this ENTIRE help.
3. Install C3DRENESG in Civil 3D.
4. Familiarize yourseLAMINA with commands available in C3DRENESG.
5. Create sections of gutters and ditches with the command CEditSarj
6. Set alignments as gutters, with the command CdefSarj
7. Edit the properties of the gutter with the command SarjProps
   On the screen that opens this command, you must configure:
   1. Select section of gutter
   2. Select reference alignment
   3. Set the value of the equivalent width of the contribution area
   4. Set the value of the coefficient of waterproofing
   5. Set the height of the spillway, if any
8. Set hydrology parameters, in the Hydrology tab
9. Check the graphics in the Graphics tab checking where to add water exits the gutters with the command SarjAddNo
10. If you have many gutters, may be more interesting to calculate using the spreadsheet ( CSarjeta)