Options - Slope Patterns

The Slope Patterns category controls the default properties for drawing the slopes of excavated trenches

The properties of the Slope Patterns category are:

• Draw Slope Pattern (AddSlopePattern, Boolean) - indicates whether the slope pattern will be drawn
• Height Limit (SlopePatternLimitHeight, Boolean) - indicates the limit to which the slope pattern is drawn from the crest to the foot of the slope
  Consider the following: Trapezoidal concrete trenches may have elevations lower than the terrain. In this case, the slope pattern can be interrupted at the edge of the device, since its base is buried.
• Standard Spacing (SlopePatternIncr, Double) - longitudinal spacing of the slope pattern lines in relation to the length in plan

Note: These properties only affect new devices and new typical sections.